新闻动态
V 型槽地板采用的是二次倒角,采用转印工艺,先倒角再模压,连接时相比较稳定。V型槽用油漆封边或用转移膜,企口处没有耐磨层。优点是立体感强,对铺装面积没有要求,小面积也能出效果。但因耐磨层的缺失和槽口较深容易藏灰出现黒缝,营销美观。
V-groove floor is a secondary chamfering, using transfer printing process, chamfering first and then molding, the connection is relatively stable. The V-groove is sealed with paint or transfer film, and there is no wear-resistant layer at the groove. The advantage is strong sense of three-dimensional, there is no requirement for pavement area, small area can also produce effect. However, due to the lack of wear-resistant layer and deep notch, it is easy to hide ash and black seam, which makes the marketing beautiful.
U 型槽是一次模压成型技术,企口处有耐磨层,槽型浅,底部为圆弧状,不容易藏灰。它的优点是好打理不容易藏灰,铺装效果大气美观。但U型槽是模压一次成型的,模压时的压力越大,倒角处基材被压溃产生裂纹,被压溃的部位在地板的使用过程中产生不规则的回弹,使倒角边基材的裂纹进一步加强,导致倒角处的耐磨层一起开裂,连接稳定性相对较差。
U-groove is one-time molding technology. There is a wear-resistant layer at the groove. The groove is shallow and the bottom is arc-shaped, so it is not easy to hide ash. Its advantages are good care, not easy to hide ash, paving effect atmosphere beautiful. However, the U-shaped groove is molded at one time. The greater the pressure during molding, the base material at the chamfer is crushed to produce cracks, and the crushed parts produce irregular springback during the use of the floor, which further strengthens the cracks of the base material at the chamfering edge, resulting in the joint cracking of the wear-resistant layer at the chamfering, and the connection stability is relatively poor.
其次V型槽木地板可以避免拼缝处膨胀凸起,因而不用担心出现白边、起翘的现象。而U型槽却比V型槽更宽、更平整,这样不会形成灰尘死角,对于日后的保养和清洁带来方便。
Secondly, V-groove wood floor can avoid expansion and bulge at the joint, so there is no need to worry about the phenomenon of white edge and warping. However, the U-shaped groove is wider and smoother than the V-shaped groove, which will not form dust dead angle, which is convenient for future maintenance and cleaning.

版权 © 保定市清苑区大进模具加工厂  推荐产品:u型槽模具,电缆槽模具,水沟盖板模具等   网站制作:保定遨游公司